Built Right Pasadena ConcreteBuilt Right Pasadena Concrete

Concrete Contractor in Burbank, CA - Driveways and Patios Built Right Underneath

Built Right Pasadena Concrete is a concrete contractor working in Burbank, CA. We build driveways, patios, walks, steps and slabs for Burbank homeowners, and we pour foundations, footings and lots and cut concrete for property owners.

A circular gray stone block fire pit sits on patterned stamped concrete paving.

Burbank driveways, walks and patios we work on

Most of our Burbank calls come from homeowners looking at a driveway that's cracked across, a front walk lifted at a joint or a back patio that holds water by the door. That's flatwork, the driveways, walks, patios and slabs that lie on the ground, and it's the same work we do in Glendale and East Los Angeles from our base in Pasadena. The price moves with the size of the slab, how much old concrete comes out, how much base has to be dug out and packed, and the finish you pick. The schedule turns on the tear-out, the base work and curing, the wait while new concrete hardens before it can take feet and then tires. Your written estimate puts your own figure on the price.

Burbank runs from flat valley streets up to hillside lots toward Stough Canyon, and the ground changes the job. On the flat streets the question is usually what's under the old slab, while up the hill it's also where the water runs and how hard the slope pushes on a slab or a wall.

Why Burbank slabs crack, sink and hold water

These are the problems I see most when I walk a Burbank driveway or patio before an estimate, and nearly all of them start under the concrete, not on top of it.

  • Older driveways here were often poured on dirt raked level instead of dug out and packed, so they settle as the ground does.

  • A patio that falls toward the house runs water back at the wall, which is why it pools by the back door.

  • Many older slabs were poured thin with little or no rebar, the steel inside that holds a cracked slab together, so cracks open and spread.

  • Cracks that wander across a slab usually mean the control joints, the grooves that tell it where to crack, were cut late or skipped.

  • A surface that chips or turns dusty usually goes back to pour day, when it was poured in midday heat or finished too soon.

Most of this is under the slab or past the edge of it, so I come out, look at the ground and the water, and write the estimate from that.

Where we work, from Pasadena to Burbank

We're based in Pasadena and work across the cities around it, Burbank included. We bring the same crew and the same way of building to La Cañada Flintridge and La Crescenta-Montrose too.

Concrete work we do in Burbank

Get a free written estimate for your Burbank concrete

We reply within one business day, and then I come out to your Burbank property myself to look at the slab, the base and the drainage. The estimate is free and written out, with no obligation, and our crew does the work only if you decide to go ahead.

Hours
Mon–Fri: 8 AM–11 PM, Sat–Sun: 6 AM–10 PM

Why Burbank homeowners hire us for concrete

I started this business in Pasadena in 2020 after years running pours for another contractor. Here's what that means when we take on a Burbank job.

  • The base gets the budget first

    The base is hidden on day one, so it's the first thing people want to cut. I'd rather trim the finish than skimp on dig-out and packing, because the base decides whether the slab settles.

  • Straight answers, licensed and insured

    We're licensed and fully insured. At the estimate I'll tell you what your ground and drainage need, even when it isn't what you hoped to hear, because a year later is too late. Your satisfaction, guaranteed.

  • I write the estimate and run the job

    The person who looks at your ground is the person on site for the pour. I write the estimate myself, our crew does the work and I run the job. Call (626) 345-7318 to get me out there.

Questions about concrete work in Burbank

Does a concrete contractor need a license to work in Burbank?

Yes, whenever the job needs a building permit, uses any hired workers or costs $1,000 or more in labor and materials. That's the rule from the state licensing board, and it covers work in Burbank the same as anywhere in California. A driveway or patio job with a crew on it falls under the license rule for that reason alone.

When is a small concrete job in Burbank exempt from the contractor license rule?

Only when the job needs no building permit, uses no hired workers and costs less than $1,000 in total. That total counts labor, materials and every other cost, even across more than one contract, and the limit was $500 until it went up at the start of 2025. The board doesn't let a bigger job be split into small contracts to get under it.

How much does a new concrete driveway cost in Burbank?

It comes down to the size of the driveway, how much old concrete has to be broken out and hauled off, how much base has to be dug out and packed, how close we can get the truck, and the finish. A broom finish, the light brushed texture that gives shoes and tires grip, costs less than stamped or colored concrete. I'll put your number on a written estimate after I see the site.

How long does a driveway replacement take before I can park on it again?

You're off the driveway from tear-out through curing, and parking on it comes last. You can walk on new concrete well before you can drive on it, because the top firms up sooner than the slab gains the strength to carry a car. The size of the job and how much base work it needs set the schedule, and we'll go over yours at the estimate.

Will my new concrete driveway in Burbank crack like the old one?

Concrete can still crack, but a slab built on a packed base with its control joints cut on time cracks much less, and where it does, it usually cracks in the grooves. The cracks we tear out usually trace back to a raked base, thin concrete with no steel or joints cut late, which is the work we don't skip.

How do I find out if my Burbank home is in a fire hazard zone?

Ask the City of Burbank, because the state fire marshal's office says to contact the local jurisdiction about a specific site in a local responsibility area. The office has already updated the fire hazard maps for state-managed areas and has since been mapping local areas and passing those maps to local governments.

Call about your Burbank concrete job

Call (626) 345-7318 or use the contact form and tell me what you're seeing, whether it's sinking, cracks or pooling water, so I know what to check when I come out.

Mon–Fri: 8 AM–11 PM, Sat–Sun: 6 AM–10 PM

(626) 345-7318Request an estimate